Miniature digital DC servo drive controller for extreme
environmental conditions. Ultra light
and intelligent digital servo drive.
Operating modes-current, velocity,
position & advance position.
The Bee is a highly durable series of featherweight ExtrIQ digital servo drives for DC brush and brushless motors, linear motors and voice coils. Despite weighing only .95 oz (27 g), the Bee can withstand extended environmental conditions and support up to 3.3 amps continuous current. Its high density allows the drive to deliver a peak of 400 W of power and 200 W of continuous power.
Based on Elmo's SimplIQ Motion Control technology, the Bee is capable of operating in position, velocity and current modes and contains a wide range of feedback and I/O options. By using Elmo's Composer software, users can easily perform drive setup, configuration, tuning, analysis and programming. The drive operates on DC power. The Bee is a PCB mounted device that enables an efficient and cost saving implementation
Feature |
Units |
3/60 |
2.5/100 |
---|---|---|---|
Minimum supply voltage |
VDC |
7.5 |
12 |
Nominal supply voltage |
VDC |
50 |
85 |
Maximum supply voltage |
VDC |
59 |
95 |
Maximum continuous power output |
W |
160 |
200 |
Efficiency at rated power (at nominal conditions) |
% |
> 99 |
|
Maximum output voltage |
95% of DC bus voltage at f=22 kHz |
||
Auxiliary power supply |
VDC |
11 – 95 VDC (up to 2.5 VA inc. 5 V/200 mA for encoder) |
|
Amplitude sinusoidal/DC continuous current (Ic) |
A |
3.3 |
2.5 |
Sinusoidal continuous RMS current limit (Ic) |
A |
2.3 |
1.8 |
Peak current limit |
A |
2 x Ic |
|
Weight |
g (oz) |
27 g (0.95 oz) |
|
Dimensions |
mm (in) |
51 x 12.5 x 42 (2" x 0.49" x 1.65") |
|
Digital in/Digital out/Analog in |
6/2/1 |
||
Mounting method |
PCB mount |
PDF Installation Guide -> Bee Digital Servo Drive Installation Guide