Heason Technology
Correct lubrication is fundamental to ball screw life

Correct lubrication is fundamental to ball screw life

Opting for the correct lubrication is fundamental to ball screw life as it ensures the ball screw performs properly for its calculated life span. Both oil and grease offer corrosion protection, however lubricant choice can depend of the type of application.

Lubricants are often taken for granted, however a correctly selected lubricant can:

A ball screw must be thoroughly cleaned to remove contamination prior to lubrication and re-lubrication. Contamination is a leading cause of premature failure of ball screws. Proper lubrication keeps contaminants out, thus greatly reducing the damage they can cause.

Which lubricant to use for your ball screw?

Oil can be applied at a controlled flow rate directly on to the point of need and will clean out any moisture or contaminants as it runs through the ball nut. It is also able to cool things down.

The only disadvantages of using oil as a lubricant for your ball screw is that it may be costly to buy the pump and metering system to apply the oil, and also excess oil may contaminate the process if it mixes with cutting fluids in a machine.

Grease is less expensive than oil, requires less frequent applications and does not contaminate process fluids.

The only disadvantages are that grease is hard to keep inside the ball nut and has the tendency to build up at the ends of the ball nut travel, where it accumulates chips and abrasive particles. The compatibility with old grease and the re-lubrication grease can also cause a problem so be sure to check this before application.

The following table shows the NLGI (National Lubricating Grease Institute) grades and the worked penetration ranges:

Below is a guide to grease quantity per circuit. To determine total volume required, you must multiply the volume determined from this figure by the number of circuits in the ball nut.

As a rule of thumb, replenish grease on your ball screw every 600 – 800 hours. Note however that because conditions can vary so widely, you should confirm this period by inspection and readjust if necessary. For extremely harsh conditions it is recommended you consult one of our technical engineers for advice on your ball screw.

Extra ball screw tips

All ball screw assemblies should run smoothly throughout the entire stroke. If the torque is not uniform over the entire stroke you need to:

Ball screws should never be run without lubrication. The right oil or grease lubrication for ball screw assemblies reduces downtime by ensuring the assemblies deliver their expected service life.

Take a look at our range of ball screws on our website or for additional manuafactuer information visit the Thomson Linear website.

Have any questions? Call us on +44 (0) 1403 792 300 or email sales@heason.com.

Date: 13 / 07 / 2017

Share this on social Media

See what is happening at Heason today
Heason Technology Limited
Motion Solutions Centre
Spring Copse Business Park
Slinfold
West Sussex
RH13 0SZ UK

Tel: +44 (0) 1403 792 300
Email: sales@heason.com

Heason Technology
A discoverIE plc company

Subscribe to our Mailing List
Keep up to date with all our latest product news & information.
Subscribe here
Facebook Twitter Google+ LinkedIn

© Copyright Heason Technology Ltd 2018